Giải pháp
100 giải pháp sẵn sàng triển khai trong mười lĩnh vực, mỗi giải pháp gồm bài toán, lộ trình giao thức, dòng sản phẩm đề xuất và danh sách kiểm tra cho quản lý dự án.
10 giải pháp
03Data Center
S21–S30S21
DCIM Data Integration
The DCIM has an SNMP interface, but half of the power and cooling plant speaks Modbus or BACnet, so its dashboards are incomplete and capacity planning relies on estimates.
Tìm hiểu thêm →S22
UPS Monitoring
UPS units from different generations report over SNMP or Modbus to separate consoles, so load, autonomy and battery alarms are not seen together by the BMS or cloud.
Tìm hiểu thêm →S23
PDU Monitoring
Rack power is estimated from nameplates, so some racks run close to breaker limits while others are stranded capacity, and customers cannot be billed per rack.
Tìm hiểu thêm →S24
CRAC/CRAH Monitoring
Precision air conditioners alarm locally on their own display, so a failed compressor or a high-pressure trip is noticed only when hall temperature rises.
Tìm hiểu thêm →S25
Data Center Cooling Monitoring
Chillers, pumps, cooling towers and CRAH units are controlled by different contractors, so the operator cannot see the whole cooling chain or measure how much energy cooling uses.
Tìm hiểu thêm →S26
Rack Environment Monitoring
Room sensors show an average temperature while individual racks overheat, and open doors or smoke inside a cabinet are not reported at all.
Tìm hiểu thêm →S27
Water Leakage Monitoring
Leaks under raised floors from CRAC units, chilled water pipes or humidifiers go unseen until equipment is wet, because the leak panel only sounds a local buzzer.
Tìm hiểu thêm →S28
UPS Battery Monitoring
One weak cell can shorten backup time for a whole string, but battery monitors are read only during the annual service visit.
Tìm hiểu thêm →S29
Generator & ATS Monitoring
Generator controllers and transfer switches are checked on weekly walk-rounds, so a failed start, a switch stuck on one source or low fuel is found too late.
Tìm hiểu thêm →S30
Data Center Unified Alarm Platform
Power, cooling, security and IT alarms arrive through SNMP traps, BMS pop-ups and vendor emails, so the on-call engineer misses the one alarm that matters in the noise.
Tìm hiểu thêm →