Çözümler
On alanda uygulamaya hazır 100 çözüm; her biri sorunu, protokol yolunu, önerilen ürün serisini ve proje yöneticisi için bir kontrol listesini içerir.
10 çözüm
03Data Center
S21–S30S21
DCIM Data Integration
The DCIM has an SNMP interface, but half of the power and cooling plant speaks Modbus or BACnet, so its dashboards are incomplete and capacity planning relies on estimates.
Daha fazla bilgi →S22
UPS Monitoring
UPS units from different generations report over SNMP or Modbus to separate consoles, so load, autonomy and battery alarms are not seen together by the BMS or cloud.
Daha fazla bilgi →S23
PDU Monitoring
Rack power is estimated from nameplates, so some racks run close to breaker limits while others are stranded capacity, and customers cannot be billed per rack.
Daha fazla bilgi →S24
CRAC/CRAH Monitoring
Precision air conditioners alarm locally on their own display, so a failed compressor or a high-pressure trip is noticed only when hall temperature rises.
Daha fazla bilgi →S25
Data Center Cooling Monitoring
Chillers, pumps, cooling towers and CRAH units are controlled by different contractors, so the operator cannot see the whole cooling chain or measure how much energy cooling uses.
Daha fazla bilgi →S26
Rack Environment Monitoring
Room sensors show an average temperature while individual racks overheat, and open doors or smoke inside a cabinet are not reported at all.
Daha fazla bilgi →S27
Water Leakage Monitoring
Leaks under raised floors from CRAC units, chilled water pipes or humidifiers go unseen until equipment is wet, because the leak panel only sounds a local buzzer.
Daha fazla bilgi →S28
UPS Battery Monitoring
One weak cell can shorten backup time for a whole string, but battery monitors are read only during the annual service visit.
Daha fazla bilgi →S29
Generator & ATS Monitoring
Generator controllers and transfer switches are checked on weekly walk-rounds, so a failed start, a switch stuck on one source or low fuel is found too late.
Daha fazla bilgi →S30
Data Center Unified Alarm Platform
Power, cooling, security and IT alarms arrive through SNMP traps, BMS pop-ups and vendor emails, so the on-call engineer misses the one alarm that matters in the noise.
Daha fazla bilgi →